No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5855-01-293-7444
NSN 6110-01-513-3474
NSN 6105-01-528-7557
NSN 5935-01-254-5100
NSN 6610-01-521-9801
NSN 6150-00-121-1996
NSN 6135-00-255-1340
NSN 5985-01-051-4934
NSN 5945-01-183-3768
NSN 5895-00-448-4059
NSN 6620-01-204-5650
NSN 5930-01-106-2835