Spline has 15 teeth; spline length is 9.647 inch; spline has pressure angle of 30 degrees; passivate shaft per qq-p-35 type 1, 2 or 3
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5930-01-538-2408
NSN 4140-01-526-6537
NSN 6320-01-108-5933
NSN 5905-00-539-5746
NSN 4140-01-139-4041
NSN 4140-01-582-9725
NSN 5910-00-852-3682
NSN 5998-00-194-2942
NSN 5990-01-338-2103
NSN 5965-01-344-8592
NSN 5895-00-379-4699
NSN 6240-01-440-9778