A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5835-01-406-4066
NSN 5945-01-571-8594
NSN 5935-00-735-9247
NSN 6645-01-133-8359
NSN 6620-00-990-3385
NSN 6220-01-054-9112
NSN 5985-00-905-5049
NSN 5965-01-386-2988
NSN 6645-01-108-7904
NSN 6320-00-116-3658
NSN 5905-00-184-6676
NSN 5855-00-560-0110