0.010 inch x 45 degrees external chamfer on first end; cross drilled through hole with 0.310 inch diameter-center line of hole located 0.243 inch from second end
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6220-01-614-0096
NSN 6145-01-430-3839
NSN 6320-01-631-7828
NSN 5999-00-358-1933
NSN 5996-00-932-2187
NSN 6645-01-546-3212
NSN 6240-00-432-7639
NSN 2925-01-364-7926
NSN 6320-01-177-3192
NSN 6220-01-181-3135
NSN 6145-00-681-1585
NSN 5920-00-221-8377