No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5999-01-626-0363
NSN 5855-00-962-5792
NSN 5930-01-568-3368
NSN 6135-01-422-1440
NSN 6220-01-526-5081
NSN 6620-00-506-0112
NSN 5930-01-581-5569
NSN 5930-00-693-5811
NSN 5920-01-485-2082
NSN 5990-01-426-7350
NSN 6145-01-339-8513
NSN 4140-01-323-4279