Case dept h 0.015 in. Min and 0.020 in. Max
No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5905-01-380-8779
NSN 6240-00-197-6819
NSN 6220-01-385-2049
NSN 6130-01-569-7044
NSN 5910-01-627-1234
NSN 6130-01-139-0290
NSN 5998-00-791-0731
NSN 2925-00-026-0005
NSN 5925-01-009-2614
NSN 6220-01-333-1319
NSN 6610-00-545-5213
NSN 6685-01-030-4140