No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5998-01-578-2240
NSN 5935-01-390-4301
NSN 5945-01-562-3292
NSN 5925-01-089-9791
NSN 2925-00-698-4882
NSN 6135-01-202-8113
NSN 6620-01-391-9829
NSN 6150-01-424-6096
NSN 6240-01-019-0348
NSN 5996-01-573-2343
NSN 5930-01-574-9911
NSN 5996-01-254-2510