A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5960-01-054-9639
NSN 5935-01-222-1256
NSN 5925-00-931-0315
NSN 5925-00-148-4513
NSN 5999-01-109-4990
NSN 7035-01-598-2394
NSN 6620-01-457-9476
NSN 5950-00-959-5429
NSN 6650-01-556-0983
NSN 5895-01-469-3115
NSN 5920-01-333-9690
NSN 5965-01-607-5753