No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5910-01-579-8118
NSN 6685-00-120-0106
NSN 6650-01-381-2972
NSN 6130-01-468-4503
NSN 6610-01-172-4041
NSN 7035-00-476-7178
NSN 6105-01-304-4388
NSN 5960-00-423-7842
NSN 6135-00-432-5567
NSN 6645-00-966-7794
NSN 6135-00-182-7008
NSN 6135-01-163-0332