A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5999-00-404-7713
NSN 7035-00-981-7216
NSN 6220-00-322-2678
NSN 6220-01-466-0447
NSN 5960-01-641-3788
NSN 5930-01-544-5964
NSN 5996-01-116-1087
NSN 5925-01-582-9829
NSN 6645-01-132-1862
NSN 6650-01-580-4321
NSN 5998-01-319-9182
NSN 5915-01-200-0360