1"uss zinc plated through hard high strength flat washer
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Parts of armored fighting vehicles,motorized, whether or not fitted with weapons
NSN 5920-01-444-1700
NSN 5925-00-412-5342
NSN 5920-01-071-7712
NSN 5985-01-069-9848
NSN 5920-01-527-7005
NSN 5960-01-218-2858
NSN 5990-00-600-6151
NSN 5930-01-400-6126
NSN 5925-01-157-7805
NSN 5935-00-896-3547
NSN 2925-00-371-2285
NSN 5895-00-518-1593