Drilled hole on second end no. 0.190-32 unf 2b thd and a 0.282 in. Radius half diameter cut from ctr of hole through end
No other part numbers with same form, fit, and function found.
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6620-01-201-4176
NSN 6320-01-445-5893
NSN 6135-00-948-7061
NSN 5985-01-411-5605
NSN 6220-00-466-2681
NSN 6620-00-244-0965
NSN 6150-01-030-1620
NSN 6685-01-598-2696
NSN 5835-00-153-4100
NSN 6610-01-140-3337
NSN 7035-01-227-7492
NSN 5950-00-010-7686