Cross drilled hole second end, 0.125 in.Dia, 0.156 in.From end; 3 no.9 woodruff keyways cut in line and 1 no.8 woodruff keyway; all are indented
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6110-01-626-8228
NSN 6620-01-533-8251
NSN 5960-00-469-1126
NSN 5895-01-185-7614
NSN 5835-01-532-9373
NSN 5895-00-774-6304
NSN 5965-00-182-7928
NSN 5965-01-399-8454
NSN 2925-01-157-9204
NSN 6610-01-026-1701
NSN 5905-00-421-6494
NSN 6105-01-578-0890