No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6130-01-050-9866
NSN 6240-01-620-2450
NSN 5930-01-359-1109
NSN 6145-00-245-8239
NSN 2925-01-560-4123
NSN 6135-01-130-3145
NSN 5945-00-233-7319
NSN 6320-01-592-6248
NSN 5999-01-170-4738
NSN 6145-01-443-3721
NSN 5950-01-394-4931
NSN 6130-01-045-7112