No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6110-00-456-2058
NSN 5985-00-765-1239
NSN 2925-01-567-8027
NSN 6320-01-170-4068
NSN 6145-01-480-8920
NSN 6320-01-154-1099
NSN 5960-00-194-1488
NSN 5910-00-270-6876
NSN 5915-00-904-1064
NSN 5975-00-282-2707
NSN 6610-01-487-8879
NSN 6645-00-189-7075