No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6130-01-372-8917
NSN 6240-01-659-8546
NSN 5915-00-835-9413
NSN 5925-00-927-6969
NSN 5930-01-477-0968
NSN 5910-01-221-5505
NSN 6110-01-027-8720
NSN 6145-00-774-4579
NSN 5930-00-678-5747
NSN 5835-01-077-4160
NSN 5985-00-450-3369
NSN 5855-01-500-0449