No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5996-01-389-4067
NSN 5985-01-541-9629
NSN 5996-00-156-5967
NSN 6135-00-347-0595
NSN 6645-01-193-8948
NSN 4140-01-472-2768
NSN 5985-01-651-3470
NSN 6685-00-476-4186
NSN 5999-00-664-1818
NSN 5950-01-089-8465
NSN 6130-01-631-4695
NSN 5835-01-310-8979