One end with 0.030 in. W by 0.010 in. Dp cross grooves, one end with 0.066 in. W single groove tapering to 0.033 in. W at bottom; both ends chamfered 0.020 in. By 45 deg
No other part numbers with same form, fit, and function found.
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5835-01-005-8564
NSN 5930-01-563-7535
NSN 6135-01-554-4281
NSN 5925-01-181-7358
NSN 6130-01-327-3261
NSN 5999-01-456-9838
NSN 5990-00-888-7761
NSN 5985-01-160-6335
NSN 6105-00-890-4982
NSN 5915-00-313-8882
NSN 6685-01-574-4311
NSN 6150-01-095-8924