No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5930-00-045-0847
NSN 6110-01-594-1028
NSN 5950-01-573-5081
NSN 6320-01-185-3857
NSN 5930-01-473-8018
NSN 5975-01-294-9684
NSN 5945-01-515-4334
NSN 5999-01-623-4391
NSN 5935-01-291-8029
NSN 6130-01-044-6382
NSN 7035-01-347-4429
NSN 7035-01-036-0236