No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 7035-00-200-5162
NSN 6130-00-775-3595
NSN 5935-01-454-4452
NSN 5910-00-548-3843
NSN 5855-01-110-9564
NSN 4140-01-029-8252
NSN 6240-01-535-6520
NSN 5996-01-368-3290
NSN 5960-01-579-1661
NSN 6145-00-008-1834
NSN 6110-01-469-5547
NSN 6220-00-960-5621