No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5895-00-903-3458
NSN 6320-00-024-1004
NSN 5925-00-644-5546
NSN 6610-00-061-7882
NSN 6240-01-221-9093
NSN 5930-00-878-1240
NSN 5965-01-258-5662
NSN 6135-00-932-3136
NSN 4140-01-650-9116
NSN 6135-01-377-5729
NSN 6135-01-093-7426
NSN 5999-01-036-9225