Cut 1.625 in. By 45 degrees 4 corners
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 7035-01-629-4362
NSN 6610-01-516-7278
NSN 5990-01-529-8433
NSN 6240-01-197-0489
NSN 5998-00-304-7467
NSN 5905-00-666-0058
NSN 6130-01-563-1114
NSN 5855-00-089-3974
NSN 5935-01-643-8299
NSN 6620-01-413-9243
NSN 5895-00-773-2926
NSN 5935-01-080-0520