Film p/n 12w7506-11 on one side only, 0.688 in. Dia, no center hole
No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5965-01-068-2714
NSN 5905-01-293-1405
NSN 6240-00-334-6766
NSN 5985-00-125-0708
NSN 5920-01-387-9972
NSN 5975-00-264-6746
NSN 5990-01-651-0170
NSN 5895-01-194-8120
NSN 5905-01-114-6987
NSN 5999-01-388-5498
NSN 6145-01-085-5556
NSN 6110-00-798-4794