No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5965-01-130-1965
NSN 4140-01-136-5530
NSN 5999-00-708-1948
NSN 6645-01-024-8199
NSN 5895-01-100-3472
NSN 5945-00-341-5272
NSN 5905-01-573-2876
NSN 6145-01-058-0899
NSN 6130-01-283-5379
NSN 5965-01-286-6548
NSN 5930-00-112-0897
NSN 6240-01-440-7922