W/center hole, 1 in. Dia
No other part numbers with same form, fit, and function found.
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5975-00-514-8614
NSN 5905-01-432-3375
NSN 6610-01-420-3780
NSN 5945-00-630-6075
NSN 5855-00-494-9581
NSN 6150-00-809-9114
NSN 6620-01-550-8573
NSN 4140-00-555-2579
NSN 5895-00-619-7939
NSN 5996-01-119-8234
NSN 6320-01-039-5891
NSN 5935-01-276-7170