No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6105-00-882-5333
NSN 6220-00-449-2107
NSN 5935-01-653-5435
NSN 6645-00-905-7258
NSN 2925-01-340-5504
NSN 5855-01-634-0259
NSN 5998-00-013-9334
NSN 6650-00-726-4242
NSN 5895-00-345-4291
NSN 6150-01-623-2882
NSN 5975-00-782-1123
NSN 5960-01-193-5224