Must be straight w/in 0.001 tir when gaged in v-blocks, diameter 0.155 inches, chamfer depth 0.010 inches, chamfer angle in degrees 45, material hardness rating 38.0 rockwell c
No other part numbers with same form, fit, and function found.
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5920-01-570-7359
NSN 6650-00-116-3432
NSN 5930-00-081-2238
NSN 6685-01-563-5227
NSN 6620-01-600-7483
NSN 6685-01-401-5360
NSN 5975-01-565-8883
NSN 5975-01-585-2342
NSN 2925-00-355-5130
NSN 5985-00-099-9522
NSN 6610-01-612-8327
NSN 5960-01-593-4760