No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6105-01-596-0865
NSN 5996-01-369-1870
NSN 6130-01-415-9179
NSN 6150-01-042-3384
NSN 5905-01-343-9219
NSN 6110-00-539-9543
NSN 6610-01-127-0724
NSN 2925-01-170-1089
NSN 5965-01-653-7321
NSN 5960-01-213-6292
NSN 5930-01-207-3451
NSN 6610-01-287-9814