No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5895-00-309-0213
NSN 6645-01-445-5235
NSN 5915-01-380-3699
NSN 7035-01-368-1070
NSN 5935-00-357-1592
NSN 6685-01-246-4638
NSN 6145-00-236-3226
NSN 5915-01-580-0308
NSN 5999-01-242-1177
NSN 5945-00-470-5080
NSN 6650-01-075-4413
NSN 5950-01-003-6669