No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6620-01-420-7465
NSN 7035-00-188-6674
NSN 6145-01-240-3909
NSN 5895-00-580-0842
NSN 5925-01-306-9601
NSN 5965-00-177-2932
NSN 6135-01-551-0562
NSN 4140-01-187-6721
NSN 5999-00-068-8976
NSN 6320-01-495-1244
NSN 6135-01-581-8163
NSN 6135-01-202-8113