No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5910-00-456-2736
NSN 4140-00-905-6570
NSN 5965-01-163-8958
NSN 6110-00-553-8816
NSN 6650-01-474-2496
NSN 6145-01-599-7239
NSN 6620-00-104-6937
NSN 5975-01-618-9697
NSN 5835-01-180-9441
NSN 6145-01-442-8143
NSN 5975-01-167-8598
NSN 2925-00-654-3206