No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5975-01-111-5599
NSN 6145-01-632-1083
NSN 5910-01-254-4373
NSN 5990-01-471-0494
NSN 5915-01-331-4022
NSN 5935-00-628-1117
NSN 6610-01-283-6739
NSN 5996-01-646-5174
NSN 5910-00-510-6612
NSN 5835-00-127-6437
NSN 4140-01-503-0034
NSN 6685-00-984-4283