Spacer plate has two squared corners on bottom edge and two rounded corners (r.078) along top edge; bolt holes are 2.406 inches apart on point 0.476 inches from bottom edge and 0.135 inches from side edges
No other part numbers with same form, fit, and function found.
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use disk, solid, plain. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see shim. For items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes gasket; insulator (as modified) and mounting pad, electrical-electronic component.
NSN 2925-00-804-8971
NSN 5835-00-725-2087
NSN 6145-01-130-9585
NSN 6105-00-969-4644
NSN 5835-01-017-3860
NSN 5905-01-513-3245
NSN 6135-01-280-2883
NSN 6650-01-219-3731
NSN 6645-00-149-1100
NSN 6650-01-339-5257
NSN 6620-01-136-5217
NSN 6685-01-056-1260