No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5835-00-794-7500
NSN 6135-01-398-5922
NSN 6650-01-250-1244
NSN 6240-01-322-4375
NSN 6110-00-042-8365
NSN 6685-01-109-2948
NSN 6135-01-616-4950
NSN 7035-00-626-1958
NSN 5925-01-150-4559
NSN 6620-01-196-2148
NSN 6240-01-422-1878
NSN 5950-01-433-8078