No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5998-01-473-3807
NSN 5835-01-506-0746
NSN 5996-01-213-5184
NSN 6610-00-734-5976
NSN 6685-01-611-8800
NSN 5910-00-452-5957
NSN 5915-01-219-4594
NSN 5945-01-466-0376
NSN 6130-01-089-9052
NSN 6650-01-467-8818
NSN 6650-01-426-4253
NSN 7035-01-339-3665