No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6135-01-190-2628
NSN 5935-01-523-1971
NSN 6650-00-550-6111
NSN 5925-00-517-8512
NSN 6650-01-301-3310
NSN 6110-00-510-3788
NSN 5905-00-941-5028
NSN 5965-01-651-8613
NSN 5930-01-445-5408
NSN 5835-01-162-3042
NSN 5920-01-329-7506
NSN 6150-01-222-0764