No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6145-01-578-4898
NSN 6610-01-014-3964
NSN 5950-01-074-1819
NSN 6105-01-214-5788
NSN 5950-00-231-6204
NSN 5950-01-578-5818
NSN 5930-01-044-0512
NSN 5960-01-632-6576
NSN 4140-01-476-2767
NSN 5996-01-293-9220
NSN 2925-01-394-9658
NSN 6645-01-180-6219