No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 7035-01-214-5171
NSN 6240-01-653-3221
NSN 5935-01-076-7707
NSN 5985-01-100-3471
NSN 6320-01-498-4954
NSN 6320-01-352-8084
NSN 5855-01-612-1358
NSN 6110-00-442-7657
NSN 5965-01-194-3453
NSN 6320-01-616-0843
NSN 5835-01-306-5511
NSN 6105-01-024-5221