No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6645-01-225-4768
NSN 5835-01-286-3600
NSN 5835-00-483-7615
NSN 5930-00-913-5231
NSN 5935-01-571-6967
NSN 5945-01-563-5914
NSN 5920-01-624-1102
NSN 6105-01-142-4551
NSN 6150-00-852-0995
NSN 5950-00-269-4805
NSN 6320-01-512-2031
NSN 4140-00-531-6696