No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5975-01-553-6861
NSN 5930-01-044-5068
NSN 6610-01-278-2446
NSN 5910-01-303-1397
NSN 5895-00-285-6622
NSN 4140-01-648-0764
NSN 6320-01-136-6842
NSN 5950-00-536-3928
NSN 6645-01-513-4782
NSN 5985-01-634-0635
NSN 6105-01-372-5755
NSN 6685-00-281-2840