No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5960-01-564-5044
NSN 5910-00-141-3868
NSN 2925-00-066-9700
NSN 5855-01-364-1005
NSN 6150-01-600-4806
NSN 5985-01-468-0105
NSN 5905-00-862-9754
NSN 5910-01-396-7621
NSN 5985-00-598-4707
NSN 5998-00-578-4360
NSN 6150-01-087-3573
NSN 5920-00-827-6017