0.046 in. Diameter x 0.094 in. Deep hole on first end
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5996-01-281-7336
NSN 5835-01-303-6563
NSN 5855-00-482-9876
NSN 6150-00-929-3539
NSN 6135-00-165-3756
NSN 6620-01-165-3784
NSN 5835-01-642-4705
NSN 5915-01-171-4941
NSN 5945-01-013-0953
NSN 6135-00-983-9187
NSN 5915-01-375-3373
NSN 6685-01-254-3014