No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6620-01-601-7491
NSN 5930-00-958-0432
NSN 5910-00-644-7300
NSN 5945-00-431-7804
NSN 5950-00-295-3034
NSN 6105-00-275-0826
NSN 5835-00-518-4507
NSN 5975-01-372-6692
NSN 5910-01-095-4618
NSN 5965-00-335-0305
NSN 5915-01-235-6318
NSN 4140-00-069-5154