No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5835-00-505-2516
NSN 5960-01-462-1864
NSN 5999-01-590-9829
NSN 5985-01-145-2810
NSN 5930-00-636-2709
NSN 5920-01-201-9144
NSN 7035-01-632-4537
NSN 6145-00-929-4205
NSN 5965-01-467-5471
NSN 4140-01-168-0661
NSN 6145-00-431-8376
NSN 5835-01-216-7289