First end to be knurled for 1/2-35 s.A.E. Serrations max diameter of serrations .502; second end drill through hole at 48 degrees angle w/dia .173
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5920-01-275-5414
NSN 6650-01-431-8933
NSN 6150-01-202-8957
NSN 6130-00-892-4818
NSN 6320-00-036-3688
NSN 5915-00-892-3011
NSN 5895-01-006-2309
NSN 6105-01-576-7080
NSN 4140-01-480-8634
NSN 6150-01-469-3089
NSN 5910-01-061-1443
NSN 5965-01-231-9125