A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Spain 
Denmark 
Greece Classification: Copper washers including spring washers not threaded
NSN 7035-01-551-1240
NSN 5935-00-504-5968
NSN 6685-01-327-3286
NSN 5945-00-832-6879
NSN 5999-01-159-0959
NSN 5930-01-016-2499
NSN 5920-01-053-9797
NSN 5920-01-602-3351
NSN 5920-01-441-2286
NSN 6105-01-398-7495
NSN 5960-01-481-8051
NSN 5935-01-337-3849