No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5985-00-652-1631
NSN 7035-00-096-9986
NSN 6320-01-285-1922
NSN 5910-01-241-1181
NSN 5905-01-469-7259
NSN 5905-01-361-9076
NSN 5945-01-436-2861
NSN 6105-01-445-5247
NSN 5985-00-966-4060
NSN 5950-01-383-8969
NSN 5975-00-119-3977
NSN 6240-01-171-6452