No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6105-01-369-6173
NSN 5920-01-043-4848
NSN 6130-00-518-1723
NSN 2925-01-575-3192
NSN 6650-01-536-3977
NSN 5996-00-235-0823
NSN 5895-01-207-0753
NSN 5965-01-398-8871
NSN 6130-00-025-4857
NSN 5895-01-055-6812
NSN 6105-01-519-1922
NSN 5950-01-212-6288