No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 7035-00-476-7178
NSN 6150-01-013-9492
NSN 6645-01-492-5304
NSN 6685-01-608-3578
NSN 6685-01-484-9276
NSN 5985-01-308-3402
NSN 5925-00-211-0205
NSN 2925-01-397-2495
NSN 5960-01-509-8779
NSN 5960-00-315-0358
NSN 5999-01-255-6659
NSN 5965-00-289-6280