No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5975-00-358-7916
NSN 7035-01-024-9511
NSN 6610-00-810-8326
NSN 5999-00-882-8720
NSN 4140-01-412-5495
NSN 6150-00-761-9817
NSN 4140-01-058-6603
NSN 5998-00-100-0491
NSN 6320-00-284-1524
NSN 6610-01-193-2169
NSN 6135-01-384-3915
NSN 6110-00-477-7932